Printed Circuit Board Gear Selector Assembly/Top Panel Geartronic, Replacing

Printed circuit board gear selector assembly/top panel Geartronic, replacing

Removal

Removing the gear selector knob
Remove the gear selector knob. See Gear selector knob, Geartronic, replacement Gear Selector Knob, Geartronic, Replacement.

Removing the center console

S60R (B5254T4 engine)
Remove the center console.

S60 (other engines)
Remove the center console. See(-2004) or(2005-).

V70R (B5254T4 engine)
Remove the center console.

V70 (other engines)
Remove the center console. See(-2004) or(2005-).

V70XC/XC70
Remove the center console. See(-2004) or(2005-).

Removing the top panel from the gear selector assembly




Separate the connectors.

Remove:
- the rear connector
- the cables from the clips.

Removing the gear selector assembly stop




Use a screwdriver.
Insert the screwdriver in the slots (1-4). Carefully pry in towards the gear selector assembly with the screwdriver. Pull the gear selector assembly stop up to release the locking

Removing the printed circuit board from the gear selector assembly stop




Release the holder from the gear selector assembly stop.
Remove the printed circuit board. Press out both the catches in the printed circuit board.
Pull the printed circuit board straight out of the holder.

Removing the gear selector boot from the top panel




Press out the 4 catches from the top panel. Remove the boot.
Replace the top panel and printed circuit board.
Transfer the boot to the new top panel.

Installation

Installing the printed circuit board on the holder and gear selector stop





Install:
- the printed circuit board in its holder. Secure it using the 2 catches
- the holder on the gear selector assembly stop. Lock it into place.

Installing the gear selector assembly stop




Press the gear selector assembly stop into place in the gear selector assembly.

Note! Check that the gear selector assembly stop is securely in place.

Installing the top panel on the gear selector assembly





Note! First install the locking sleeve for the boot on the gear selector lever.

Connect the connectors to the gear selector assembly switches.
Install the connectors on gear selector assembly.

Installing gear selector knob
Install the gear selector knob. See Gear selector knob, Geartronic, replacement Gear Selector Knob, Geartronic, Replacement.

Checking the shift positions




Switch on the ignition.
Shift the gear selector through all the shift positions.
Ensure that the letters and/or digits on the display on the combined instrument panel correspond to the shift positions on the top panel.