Replacing Dashboard and Tunnel Compartment Switches

Replacing dashboard and tunnel compartment switches

Removing




Ignition off.
Carefully insert a screwdriver or weatherstrip tool between the panel and the top of the rocker switch. Carefully pry outwards until the switch can be gripped with the fingers. Pull out the switch.

Note! Put something between the screwdriver and the surrounding panel so as not to damage it.

Disconnect connector.

Note! The hazard warning signal flasher switch is located under the radio and is replaced in the same way as the other switches.

Installing
Connect connector. Check that the rocker switch works before installing it in the panel.
Reinstall rocker switch, press into place in panel.
- Test switch function.