Spray Nozzle Holder

Spray Nozzle Holder

• Washer nozzle holder can also be removed and installed with bumper installed.

Removal

- Turn off the ignition and all electric consumers and remove the key.

- Pull the spray nozzle out of the bumper cover all the way and remove the cap - 1 - from the pins on the spray nozzle holder.






- Lift securing clip - arrow - slightly using a small screwdriver.






- Pull out washer nozzle bracket.

Installation

• Use the spray nozzle bracket to adjust how far the cap on the nozzle is pulled into the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Slide spray nozzle holder into lift cylinder until it engages.

- Remove the cap on the spray nozzle holder and lower the lift cylinder.

- Check cover cap for correct seating on bumper cover.

- Adjust the cap if necessary by shifting the spray nozzle holder into a higher or lower catch on the lift cylinder.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.