Exhaust System, Aligning

Exhaust System, Aligning

• Align the exhaust system when cold.

• Tightening specifications, refer to => [ Muffler and Mounts Overview ] Service and Repair.

- Loosen the nuts on the front clamping sleeves.

- If present, loosed the nuts on the rear clamping sleeves.

- Push the exhaust system forward - arrow - until the following tensions are adjusted on the individual retaining loops:






• Right front retaining loop: Dimension - a - = 2 mm.

• Left front retaining loop: Dimension - a - = 4 mm.






• Left and right rear retaining loops: Dimension - a - = 10 mm.






- Hold the exhaust system in this position and tighten the clamping sleeve nuts evenly.

• A 2nd technician is needed to align the exhaust system with clamping sleeves between the center and rear mufflers.

• If all adjustment dimensions are not achieved, remove the affected suspended mount from body and shift accordingly.

- Align the tail pipes. Refer to => [ Attach the tail pipe to the rear muffler and align it. ] Exhaust Tailpipe, Replacing.