Crankshaft Seal, Timing Chain Side

Crankshaft Seal, Timing Chain Side

Special tools, testers and auxiliary items required

• Assembly Tool (T10122)

• Pulling Hook (T20143/2)

Removing

• The engine or transmission is removed.

- Remove the drive plate. Refer to => [ Drive Plate ] Drive Plate.

- Pry out the seal using the pulling hook (T20143/2).






Installing

- Drill a 8 mm hole - arrow 2 - in the guide sleeve (T10122/2) for the alignment sleeve.






- Use the hole - arrow 1 - in the washer as a template when drilling.

- Clean the running and sealing surfaces.






- Place the assembly device (T10122/1) on the pull sleeve (T10122/2) and slide the seal - A - onto the pull sleeve.

- Remove the guide sleeve.

- Position the pull sleeve with the seal on the crankshaft.






- Press in the seal all around evenly and flush using the pressure sleeve (T10122/3).






- Install the drive plate. Refer to => [ Drive Plate ] Drive Plate.