Gearshift Mechanism Trim

Gearshift Mechanism Trim

Removing

• Place the selector lever in the "N" position.

• Open the storage compartment/ashtray unit.

- Turn off the ignition.

- Unclip the selector lever boot.

- In the selector mechanism opening, grasp on the right side under the trim - 1 - and carefully unclip it - arrow A -.






- In the selector mechanism opening, grasp on the left side under the trim and carefully unclip it.

- Slide the trim slightly forward in the direction of travel - arrow B -, pull it out in an upward direction and disconnect the harness connectors.

Installation

- To install, perform the steps used for removal in reverse order.