Spray Nozzle Lift Cylinder

Spray Nozzle Lift Cylinder

Do not remove the spray nozzle lift cylinders by hand.

Depending on the design, a lift cylinder, which was manually removed, can jam up during the return stroke.

Do not manually push the lift cylinder back down; this will damage the lift cylinder.

A jammed lift cylinder will become functional again once it activated by the system.

The lift cylinders come out only with water or air pressure.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the spray nozzle holder. Refer to => [ Headlamp Spray Nozzle Holder ] Headlamp Spray Nozzle Holder.

- Remove the front bumper cover.

- Press the button - arrow - and the pull the lift cylinder - 1 - to the rear and out of the bracket.






Installing

Installation is performed in the reverse order of removal. Note the following:

- Bleed the headlamp washer system after conclusion of the assembly steps. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.