Adaptive Chassis DCC Shock Absorber, FWD

Overview: Adaptive Chassis DCC Shock Absorber, FWD






1 Low Spring Support

• Spring end rotated up to stop

2 Coil Spring

• There are different suspension versions. Refer to => [ Vehicle Data Label ] Application and ID.

• Removing and installing, refer to => [ Coil Spring, FWD ] Coil Spring, FWD

3 Upper Spring Support

4 Bracket

• for the rear body acceleration sensor (G343)

• Removing and Installing

5 Rear Body Acceleration Sensor (G343)

• Removing and installing, refer to => [ Rear Body Acceleration Sensor (G343), FWD ] Rear Body Acceleration Sensor (G343), FWD

• Note the installation position of the retainer => [ (Item 4) Bracket ] => [ Installation position on the retainer ]

6 Bolt

• 5 Nm

• Always replace if removed.

7 Bolt

• 180 Nm

• M14 x 1.5 x 85

• Always replace if removed.

8 Bolt

• 50 Nm + 90°

• M10 x 35

• Always replace if removed.

9 Shock Absorber with Left and Right Rear Dampening Adjustment Valve (N338/N339)

• Removing and installing, refer to => [ Adaptive Chassis DCC Shock Absorber, FWD ] Adaptive Chassis DCC Shock Absorber, FWD

• There are different suspension versions, => [ Vehicle Data Label ] Application and ID vehicle data plate.

10 Washer

11 Lower Transverse Link

• Removing and installing, refer to => [ Lower Transverse Link, through MY 2010 FWD ] Lower Transverse Link, through MY 2010 FWD

12 Wheel Bearing Housing

• Removing and installing, refer to => [ Wheel Bearing Housing, FWD ] Wheel Bearing Housing, FWD

Installation position rear body acceleration sensor (G343) on the retainer





The tab on the retainer - 1 - must fit into the recess in the rear body acceleration sensor (G343) - arrow -.