Tie Rod, FWD

Tie Rod, FWD

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Torque wrench (V.A.G 1332)

Removing

- Remove the wheel.

- Remove coil spring => [ Coil Spring, FWD ] Coil Spring, FWD.

- Remove the nut - 1 - and pull coupling rod - 2 - out of stabilizer.






- Remove bolt - arrow - for tie rod - 3 -.

- Remove bolts - arrows - for stabilizer clamp.






- Remove the nut - arrow - and remove bolt toward rear.






- Remove tie rod - 1 -.

Installing

- Insert tie rod into vehicle and tighten the bolts by hand.

• The tie rods must be closed in the direction of travel.

The bolted connections of the tie rod must only be fastened when the dimension "a" is achieved => [ Measure dimension -a-. ] Rear Suspension!

- Fasten the tie rod - 1 - to the subframe and tighten the new nut - arrow -.






- Tighten bolts - arrows - for stabilizer clamp.






- Tighten bolt - arrow - for tie rod - 3 -.






• Make sure a washer is installed between the tie rod and the wheel bearing housing.

- Insert coupling rod - 2 - into stabilizer and tighten nut - 1 -.

- Install coil spring => [ Coil Spring, FWD ] Coil Spring, FWD.

- Install the wheel and tighten the wheel bolts. Refer to => [ Tightening Specification for Mounting Wheels ] Specifications.

- Perform vehicle alignment => [ Vehicle Alignment Procedure ] Vehicle Alignment Procedure.

Tightening Specifications