Rear Lid Tail Lamp Bulb

Rear Lid Tail Lamp Bulb

• The following illustrations show removing and installing the left tail lamp bulb (M4) on a RHD vehicle. Removing and installing the right tail lamp bulb (M2) is identical.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Unclip the service cover - 1 - and remove it from the trim panel in - direction of arrow -.






- Disconnect the connector - 1 -.






- Push the retainer - 1 - in - direction of arrow - and remove the bulb holder - 2 -.






- Pull the tail lamp bulb - 3 - in the - direction of the arrow - straight out of the lamp socket - 1 -.






Tail lamp bulb : 12V, 16W

Installing

Installation is performed in the reverse order of removal. Note the following:

- After installation, check the tail lamp functions.