Engine/Transmission Mount, Adjusting

Engine/Transmission Mount, Adjusting

• Always use two brackets with spindles and hooks (10-222 A/10). Otherwise the engine support bridge (10-222 A) will have a tendency to tip.

Special tools, testers and auxiliary items required

• Engine Support Bridge (10-222 A)

• Adapter (10-222 A/22) (Qty. 2)

• Engine Support Adapter (10-222 A/3) (Qty. 2)

• Bracket with Spindle and Hook (10-222 A/10) (Qty. 2)

• Shackle (10-222 A/12)

• Lifting Eyebolt (3368) (For automatic transmissions only)

Procedure

- Remove the engine cover. Refer to => [ Engine Cover ] Engine Cover.

- Remove the air filter housing. Refer to => [ Air Filter Housing ] Air Filter Housing.

Danger of causing damage to other electronic components when disconnecting the battery.

• Complete the steps for disconnecting the battery.

- With the ignition turned off, remove the ground wire - arrow - from the battery.






- Remove the battery.

- Remove the battery tray bolts - arrows - and tray.






with a Automatic Transmission






- Install the lifting eyelet (3368) to the transmission mount bracket as shown.

- Install the engine support bridge (10-222 A) using the following special tools:






• Adapter (10-222 A/22) , Qty. 2

• Engine support adapter (10-222 A/3) , Qty. 2

• Bracket with spindle and hook (10-222 A/10) , Qty. 2

• Shackle (10-222 A/12)

with a Manual Transmission






- Remove the shift mechanism from the transmission.

- Install the engine support bridge (10-222 A) using the following special tools:

• Adapter (10-222 A/22) , Qty. 2

• Engine support adapter (10-222 A/3) , Qty. 2

• Bracket with spindle and hook (10-222 A/10) , Qty. 2

• Shackle (10-222 A/12)

Continuation for All

- Support the engine and the transmission but do not lift it.

- Replace the engine mount to engine mount bracket bolts - arrows - one after the other if this was not already performed when the engine was installed and tighten them hand tight.






with a Manual Transmission






- Replace the transmission mount to transmission mount bracket bolts - arrows - one after the other if this was not already performed when the engine was installed and tighten them hand tight.

with a Automatic Transmission






- Replace the transmission mount to transmission mount bracket bolts - arrows - one after the other if the was not already performed when the engine was installed and tighten them hand tight.

Continuation for All

- Loosen the engine and transmission mount to bracket bolts approximately 2 turns.

- Adjust the engine and transmission mounts and hand tighten the bolts.

Engine Mount






• There must be a distance of at least 10 mm - a - present between the engine mount bracket - 2 - and right longitudinal member.

• The casting edge on the engine mount bracket - 2 - must be parallel to the engine mount support arm- 1 -.

Transmission Mount






• The edges of the transmission mount support arm - 1 - and transmission mount - 2 - are parallel.

• Dimension - x - is the same size on both sides of the mount.

- Tighten the engine and transmission mount to bracket bolts to specifications. Refer to => [ Engine/Transmission Mount Overview ] Service and Repair.

Further installation is in the reverse order of removal.