Flywheel: Service and Repair

Flywheel

Special tools, testers and auxiliary items required

• Counter-Hold Tool (T10044)

Removing

• To prevent damage to the dual-mass flywheel when removing, the bolts - B - must not be loosened using an air powered or impact wrench. Only removing the bolts - B - by hand is permitted.






- Remove the transmission.

- Rotate the flywheel - A - until the bolts - B - line up with the holes - arrows -.

- Be careful the bolt heads - B - do not get caught on the flywheel when removing them.

- Securely attach the counter-hold tool (T10044) with a washer - arrow - to the cylinder block. To loosen the flywheel, move the counter-hold tool (T10044) into - position A -.






- Mark the flywheel position to the engine.

- Remove the flywheel bolts and flywheel.

Installing

Install in the reverse order of removal. Note the following:

- Replace the bolts.

Move the counter-hold tool (T10044) into - position B - to tighten the flywheel bolts.






Tightening Specifications