Driveshaft, Triple Roller Joint AAR3300i Assembly Overview

Driveshaft, Triple Roller Joint AAR3300i Assembly Overview






1 Outer CV Joint

• Replace only as complete unit.

• Removing, refer to => [ Driveshaft with Triple Roller Joint AAR3300i ] Driveshaft with Triple Roller Joint AAR3300i

• Installing: Drive onto shaft using plastic hammer until compressed circlip seats.

• Checking, refer to => [ Outer CV Joint, Checking ] Outer CV Joint, Checking

2 Bolt

• 200 Nm + 180°

• Always replace if removed.

• Bolt, Loosening and Tightening, refer to => [ Fastener Tightening Specifications ] Front Suspension

3 Locking Ring

• Always replace if removed.

• Insert in shaft groove

4 Thrust Ring

• Installed position => [ Installed Location Of Spring Washer And Thrust Washer On Outer Joint ] Driveshaft with Triple Roller Joint AAR3300i

5 Plate Spring

• Installed position => [ Installed Location Of Spring Washer And Thrust Washer On Outer Joint ] Driveshaft with Triple Roller Joint AAR3300i

6 Clamp

• Always replace if removed.

• Tensioning => [ Tightening Hose Clamp On Outer Joint ] Driveshaft with Triple Roller Joint AAR3300i

7 CV Boot

• Check for tears and scuffing

• Material: Hytrel (Polyelastomer)

8 Clamp

• Always replace if removed.

• Tensioning => [ Tightening Hose Clamp On Outer Joint ] Driveshaft with Triple Roller Joint AAR3300i

9 Driveshaft

10 Clamp

• Always replace if removed.

• Tensioning => [ Tightening Hose Clamp On Outer Joint ] Driveshaft with Triple Roller Joint AAR3300i

11 CV Boot for Triple Roller Joint

• Check for tears and scuffing

12 Clamp

• Always replace if removed.

• Tensioning => [ Tightening The Tensioning Clamps On The Larger Diameter On The Inner Joint. ] Driveshaft with Triple Roller Joint AAR3300i

13 Triple Roller Star with Rollers

The chamfer - arrow - points to drive axle splines.

14 Locking Ring

• Always replace if removed.

• Insert in shaft groove

15 Internal Multi-Point Bolt

• first tighten diagonally to 10 Nm, then tighten diagonally again to the tightening specification

• 70 Nm

• M10 x 23

16 Joint