Engine Name Badges

Engine Name Badges

Assembly Information

• Heat the name plates or emblem before removing using hot air blower (V.A.G 1416).

• If installing a name badge for the first time on a new vehicle or a newly painted surface, follow the procedure described in => Paint Repair Information; =>Paint Repairs; =>Paint Finish; =>Decorative Molding and Films.

• Use only adhesive remover (D 002 000 10) to remove any remaining adhesive when removing a name badge or emblem.

• Remove any adhesive residue left by the tape using adhesive remover (VAS 6349).

• Make sure the adhesive surfaces are free of dust and grease.

• Install the name badges or brand emblem immediately after cleaning.

• Only remove the protective film right before assembly.

• The temperature must be approximately 70°F (21 °C).

• It is not possible to remove the name plates or emblem without damaging them.

TDI, TDI SE, 3.6, 3.6 SE, SEL and SE

• The height dimension of the engine name badges - TDI -, - TDI SE -, - 3.6 -, - 3.6 SE -, - SEL - and - SE - is identical.

• Follow the instructions for installing the name badges.






1 Name badge

• Engine designation

• Follow the installation instructions.

2 Rear lid

3 Height dimension

• For the engine designation - TDI -, - TDI SE -, - 3.6 -, - 3.6 SE -, - SEL - and - SE -

• 45 +/- 1 mm, from the name badge to the tail lamp assembly

4 Tail lamp

5 Side dimension

• For the engine designation - TDI -, - TDI SE -, - 3.6 SE -, - SEL - and - SE -

• 20 +/- 1 mm, from the outer edge of the rear lid to the name badge

6 Rear bumper cover

7 Side dimension

• Engine designation - 3.6 -

• 18 +/- 1 mm, from the outer edge of the rear lid to the name badge

TDI SEL and 3.6 SEL

• The height dimension for the engine name plates - TDI SEL -, - 3.6 SEL - is identical.

• Follow the instructions for installing the name badges.






1 Name badge

• For engine designation - TDI SEL - and - 3.6 SEL -

• Follow the installation instructions.

2 Rear lid

3 Height dimension

• For engine designation - TDI SEL - and - 3.6 SEL -

• 45 +/- 1 mm, from the name badge to the tail lamp assembly

4 Tail lamp

5 Rear bumper cover

6 Side dimension

• For engine designation - TDI SEL -

• 10 +/- 1 mm, from the outer edge of the rear lid to the name badge

7 Side dimension

• Engine designation - 3.6 SEL -

• 15.5 +/- 1 mm, from the outer edge of the rear lid to the name badge