Plastic Relay Lever
Plastic Relay Lever
A plastic relay lever is installed from 05.07. Two versions may be installed.
• Relay lever with a catch
• Relay lever with clip
Note the following when removing and installing:
• To remove the relay lever, it is necessary to remove the cable retainer from the selector cable.
This prevents damage to the selector cable.
- Pull the securing mechanism all the way forward in the - direction of arrow 1 - and then unlock it in the - direction of arrow 2 -.
- Push the relay lever forward (in the - direction of arrow 3 -).
Relay Lever with Tab - arrow 1 -
- Push the catch - arrow 1 - all the way down and remove the relay lever and cable retainer. Move the relay lever in its operating direction.
Relay Lever with Clip - arrow 1 -
- Remove the clip - arrow 1 - and then remove the relay lever and the cable retainer.
Continuation for All
• The cable retainer must be behind the catch - arrow 2 -.
• The cable retainer may only be removed with the relay lever removed.
• Lubricate the bearing areas and sliding surfaces when installing.
• For the correct grease, refer to the Parts Catalog.
- Press the cable retainer onto the relay lever.
- Install the relay lever together with the cable retainer as far as the stop.
Relay Lever with Tab - arrow 1 -
• The catch - arrow 1 - secures the relay lever.
• Make sure it engages securely.
• The cable retainer must be behind the catch - arrow 2 -.
Relay Lever with Clip - arrow 1 -
• The clip - arrow 1 - secures the relay lever.
• Make sure the clips locks securely.
• The cable retainer must be behind the catch - arrow 2 -.
Removing the Selector Cable Retainer from a Plastic Relay Lever
• The relay lever is removed.
- Insert a screwdriver - A - between the bushing - B - and the relay lever.
Installing the Cable Retainer
• The relay lever is removed.
• The cable retainer may only be installed at the bushing - arrow -.
• The cable retainer must move freely on the relay lever.
• It must be behind the tab - arrow 2 -.