Wiper Motor: Service and Repair

Windshield Wiper Motor (V)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Pry Lever (80-200)

- Pry off ball head - arrow - of linkage - 1 - from motor crank using (80-200).






- Remove the nut - 1 -.






- Remove the motor crank - 2 - from the windshield wiper motor shaft.

- Remove the mounting bolts - arrows - and remove the windshield wiper motor with the windshield wiper motor control module (J400) from the wiper frame.

Installing

- Install the windshield wiper motor with the windshield wiper motor control module in the wiper frame and tighten the bolts - arrows -.






- Tighten the threaded connections to the tightening specification. Refer to => [ Windshield Wiper System Overview ] Windshield Wiper System Overview.

- Mount the motor crank - 1 - on the windshield wiper motor shaft.

Distance - a - to stop - 2 - must be 3 +/- 1 mm.






- Tighten the motor crank and the windshield wiper motor shaft with the nut - 3 -.

- Tighten the threaded connections to the tightening specification. Refer to => [ Windshield Wiper System Overview ] Windshield Wiper System Overview.

- Push the ball head - arrow - on the linkage - 1 - onto the motor crank.