Windshield Washer Fluid Reservoir

Windshield Washer Fluid Reservoir


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the front bumper cover.

- Turn the clip to unlock the hose connection and then remove it from the Windshield washer pump (V5) - 3 -.






- Catch any draining washer fluid in a suitable container.

- Release and disconnect the connector from the windshield washer pump - 3 -.

- Release and disconnect the Windshield washer fluid level sensor (G33) connector - 4 -.

- Remove the screws - 2 -, - 5 - and - 6 - and then remove the reservoir - 1 - from the vehicle.






Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Windshield Washer System Overview ] Windshield Washer System Overview.