Windshield Washer Pump: Service and Repair

Windshield Washer Pump (V5)


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the front bumper cover.

- Turn the clip to unlock the hose connection and then remove it from the windshield washer pump - 3 -.






- Catch any draining washer fluid in a suitable container.

- Pull the windshield washer pump - 2 - upward and out of the container - 1 - and release and disconnect the connector.






Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Windshield Washer System Overview ] Windshield Washer System Overview.

- Bleed the headlamp washer system after finishing assembly. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.