Headlamp Washer Spray Nozzle Holder

Headlamp Washer Spray Nozzle Holder

• Removing and installing the left spray nozzle holder is shown in the following illustrations.

• Removing and installing the right spray nozzle holder is identical.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Pull the spray nozzles and the cover cap - 1 - off up the stop and out of the bumper cover.






- Remove the cap - 1 - from the mountings - arrows - on the spray nozzle holder.

- Lift the retaining hook - arrow - slightly and remove the spray nozzle holder.






Installing

• Use the catches on the spray nozzle holder to adjust how far the cap of the spray nozzle is pulled onto the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Push the spray nozzle holder into the lift cylinder until it locks in place.

- Place the cover cap on the spray nozzle bracket and let the lift cylinder draw inward.

- Check the cap for proper seating on the bumper cover.

- Bleed the headlamp washer system after finishing assembly. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.

- Check and adjust the headlamp washer system spray jets. Refer to Maintenance Procedures.