Headlamp Washer Lift Cylinder with Spray Nozzles

Headlamp Washer Lift Cylinder with Spray Nozzles

• Removing and installing the left spray nozzle lift cylinder is shown in the following illustrations.

• Removing and installing the right spray nozzle is identical.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Pull the spray nozzles and the cover cap - 1 - off up the stop and out of the bumper cover.






- Remove the cap - 1 - from the mountings - arrows - on the spray nozzle holder.

- Remove the front bumper cover.

- Press on the clip - arrow - and pull the hose connection off of the lift cylinder.






- Press both locking mechanisms in - direction of arrow - together at the same time and pull the lift cylinder - 2 - out and downward out from the bracket in the bumper cover - 1 -.






Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Headlamp Washer System Overview ] Headlamp Washer System Overview.

- Bleed the headlamp washer system after finishing assembly. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.