Hydraulic Hose: Service and Repair

Clutch Hose/Line Assembly or Pipe

Special tools, testers and auxiliary items required

• Hose Clamps up to 25 mm Dia. (3094)

Removing

- Remove the entire air filter housing.

• While performing the following procedure, make sure no brake fluid comes into contact with the longitudinal member or the transmission. If it does, clean the area thoroughly.

- Clamp off the supply hose to the master cylinder using a hose clamp up to 25 mm dia. (3094).






Remove the hose/line assembly or pipe from the clutch master cylinder as follows:

- Pull the clip - 3 - out with a screwdriver or pointed tool and remove the hose/line - 1 - or pipe and O-ring - 2 -.







Do not press the clutch pedal after removing the hose/line or pipe.

Remove the hose/line or pipe from the breather assembly as follows:

- Pull up the clip - 2 - with a screwdriver or a pointed tool and remove the hose/line - 4 - or pipe with the O-ring - 3 - from the breather assembly - 1 -.






Installing

Install in the reverse order of removal. Note the following:

- Press in the hose/line or pipe - 1 - with the O-ring - 2 - into the clutch master cylinder connection - 4 - until the clip - 3 - engages.






- Pull on the hose/line or pipe to make sure it is secure.

- Press the hose/line or pipe with O-ring - 3 - into the breather connection until the clip engages.






- Pull on the hose/line or pipe to make sure it is secure.

- After removing the hose clamp up to 25 mm dia. (3094) , bring the supply hose back to its original shape.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] Procedures.

- Install the entire air filter housing.