Selector Handle with Cover

Selector Handle with Cover

For all handles, there is the possibility that the button can be pressed into the handle. Do not install the handle with the button pushed in.

- Pull the button out beyond its press point before removing.






- Prevent the button from being pressed in with a cable tie or wire.

- Remove the cover.

- Push the sleeve upward and unlock the handle.






- Lock the handle again after installing it. To do this, press the sleeve under the handle.

- With the new handle, only the transportation safeguard has to be removed. The button is already in the installed position.






- Disconnect the connector from the cover.

- Remove the handle upward.

- Lock the handle again after installing it. Push the sleeve under the handle.

Vehicles with the button - arrow - on the front of the handle






The button - arrow - must not be pushed in when removing and installing the handle.

- Should this happen, then unclip the handle trim upward.






- Press the small lever for the cable rod - arrow - into the groove before the handle is installed.