Rear Wheel Speed Sensor, Multi-Link Axle

Rear Wheel Speed Sensor, Multi-Link Axle

Removing

- Raise the vehicle.

- Release and disconnect the connector - 1 -.






- Remove the screw - 2 - from the wheel bearing housing.

- Remove rear wheel speed sensor from wheel bearing housing.

Installing

Install in reverse order of removal. Note the following:

- Clean the inside of the hole and coat it with hot bolt paste (G 052 112 A3) before installing the rear wheel speed sensor.

- Install the speed sensor into the hole in the rear axle and tighten it.

Tightening Specification