Rear Lid Tail Lamps

Rear Lid Tail Lamps


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removing

- Remove the service cover - 1 - from the trim panel in the rear lid.






- Disconnect the connector - 1 -.






- Remove the screws - 2 - and remove the tail lamp.

Installing

Install in reverse order of removal, noting the following:

- Check the gap dimensions on the body.

- Tighten the threaded connections to the tightening specification. Refer to => [ Rear Lid Tail Lamps Overview ] Rear Lid Tail Lamps Overview.