Instrument Cluster

Instrument Cluster

Before removing the instrument cluster, perform the => [ Instrument Cluster Replacing ] Testing and Inspection procedure to read out the data saved in the Instrument Cluster Control Module (J285).


• Switch off the ignition and all electrical consumers.

• Remove the key.

Removing

• It is not necessary to remove the steering wheel.

- Pull the steering wheel all the way out and then lower it as far down as it will go.

- Remove the upper section of the steering column trim.

- Remove the bolts - arrows -.






- Pull the instrument cluster back out of the instrument panel while being careful of the connected wires.

- Move the securing clip - 1 - in - direction of arrow - and disconnect the connector - 2 -.






- Remove the instrument cluster from the vehicle.

Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to 1.5 Nm.