Oil Separator

Oil Separator

Special tools, testers and auxiliary items required

• Torque Wrench (5-50 Nm) (V.A.G 1331)

Removing

- Remove the noise insulation.

- Remove the bolts - 9 through 1 - and remove the oil separator.







Risk of contaminating the lubricating system.

• Seal the opening with a clean cloth.

Installing

• Always replace gaskets and seals.

• Install only approved clamps for securing hose connections.

Install in reverse order of removal. When doing this note the following:

- Tighten the bolts in sequence - 1 through 9 -.






Tightening specification: 9 Nm