Brake Drum

Brake Drum

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

Removing

- Loosen the wheel bolts.

- Raise the vehicle.

- Remove the wheel.

- Push the brake back with a screwdriver. Refer to => [ Reset Rear Drum Brake ] Procedures.






- Remove the bolt - 1 -.

- Remove the brake drum - 2 - evenly.

Cleaning


Do not blow brake system using compressed air, the dust produced is harmful to health!

• Use only appropriate solvents for cleaning brake system.

Installing

Install in reverse order of removal. Note the following:

• Clean carefully and check for wear and damage, make sure the dimensions are correct and that the brake surface is perfect.

- Install the brake drum evenly over the brake pads. Be careful not to tilt the brake drum.

- Install the wheel and tighten.

- Adjust parking brake. Refer to=> [ Parking Brake, Adjusting, with Drum Brake ] Parking Brake, Adjusting, with Drum Brake.

Tightening Specification