Antenna Amplifier: Service and Repair

Antenna Amplifier (R24)/Antenna Amplifier 2 (R111)

The antenna amplifier / antenna amplifier 2 are located on the left and right C-pillars. Removal and installation is the same for both.

Removing


• Turn off the ignition and all electrical consumers.

• Remove the key.

- Remove the C-pillar trim.

- Disconnect the connectors - 3 - and - 4 -.






- Remove the screw - 1 - and remove the antenna amplifier - 2 - from the C-pillar.

Installing

Install in reverse order of removal, noting the following:

- Tighten the threaded connections to the tightening specification. Refer to => [ Antenna System Overview ] Antenna System Overview.