Rear Wiper Arm

Rear Wiper Arm

Removal

- Turn on the ignition and then operate the rear window wiper.

- Fold up the cap - 1 - on the rear window wiper and unclip it.

- Loosen the nut - arrow - but do not remove it all of the way.






• Joint-free wiper blades are very flexible. Hold the wiper blade only in the area near the wiper blade retainer in order to remove it from the rear window.

- Fold wiper arm up and loosen from the cone by sideways motions.

- Remove the nut - arrow - and the wiper arm.

Installation

- Turn on the ignition and operate the rear window wiper to move the rear window wiper motor (V12) into the park position.

- Install the wiper arm on the wiper arm shaft in its end position and tighten the nut - arrow - hand-tight.






- Adjust the rear window wiper park position. Refer to => [ Rear Window Wiper Blade Park Position, Adjusting ] Service and Repair.