Windshield Washer Pump: Service and Repair

Windshield and Rear Window Washer Pump (V59)


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the front bumper cover.

To avoid interchanging the washer fluid line connections on the Windshield and Rear Window Washer Pump , the connections on the pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

- Turn the clip on the hose connection - 3 - and - 5 - to open it and then remove the windshield and rear window washer pump - 4 -.






- Catch any draining washer fluid in a suitable container.

- Pull the windshield and rear window washer pump - 4 - out of the reservoir.

- Disconnect the connector - 2 -.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Tighten the threaded connections to the tightening specifications. Refer to => [ Windshield Washer System Overview ] Windshield Washer System Overview.

- Bleed the headlamp washer system. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.