Window Guide

Window Guide

• The following describes removing and installing the right window guide only. Removing and installing the left window guide is identical.

• The removal and installation is depicted without the outer door panel.

• Do not bend window recess seal when lifting off!

Removing






- Remove the exterior mirror. Refer to => [ Exterior rearview mirror ] Exterior rearview mirror

Vehicles with window guide trim molding

- Remove the clip - 7 - and the window guide trim molding - 2 -. Refer to => [ Window Guide Trim Molding ] .

All vehicles

- Remove the two bolts - 5 - and remove the trim - 6 - from the door - 3 -.

Make sure the rubber spacers - 4 - are not lost.

- Pull window guide - 1 - all around from window frame - 4 - and upward out of window shaft.

Installation

To install, perform the steps used for removal in reverse order.

Tightening specification: Bolt - 5 - 2 Nm

• A function test must be performed before door trim is installed.

• While installing window guide, make sure it is seated evenly (wind noise).