Headlamp Beam Adjustment Motors (V48)/(V49), Valeo

Headlamp Beam Adjustment Motors (V48)/(V49), Valeo

If the motors are removed and installed, check the headlamp position and adjust it if necessary.

• The illustrations show replacing on a right headlamp.


• Turn off the ignition and all electrical consumers.

• Remove the key.

Removal

- Remove the headlamp.

- Pull the clip - 1 - upward and remove the cap - 2 - from the headlamp.






- Turn the adjusting screw - 1 - for the low beam vertical adjustment completely in the following direction:






• Left headlamp - all around to the left

• Right headlamp - to the right

- Lift the adjusting screw - 1 - slightly with a screwdriver and pull it out of the headlamp housing.

- Disconnect the connector - 2 - from the right headlamp beam adjustment motor (V49).

- Move the right headlamp beam adjustment motor - 1 - all the way in - direction of arrow - to unlock it.






- Tip the right headlamp beam adjustment motor - 3 - so that it is possible to remove the ball head - 1 - from its mount - 2 -.






- Remove the right headlamp beam adjustment motor from the headlamp housing.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Insert the right headlamp beam adjustment motor into the headlamp.

- Connect the connector.

- Install the ball head - 1 - carefully into the ball head mount - 2 - from the top.






- Engage the right headlamp beam adjustment motor - 3 - by turning it all the way to the left.

Make sure the O-ring is installed correctly when inserting the low beam vertical adjustment screw.

- Insert the screw for adjusting the low beam vertically into the headlamp housing.


When installing the cover cap, make sure the cap is properly seated. It is destroyed by entry of water into headlamp.

- Install the cap - 2 - and secure it with the clip - 1 -.






- Check headlamp for functions.

- Check and adjust the headlamp adjustment.