Auxiliary Heater Heating Element (Z35), Vehicles From 1K-7M 119 727

Auxiliary Heater Heating Element (Z35), Vehicles From 1K-7M 119 727

Removing

- Remove driver side footwell trim.

- Remove the left footwell vent, refer to => [ Left Footwell Vent ] Left Footwell Vent.






• If the temperature door lever - C - is a position that hinders access to the upper screw - A -. Change the position of the temperature door using the hot and fresh air controls; on vehicles with Climatronic (for example, Hi setting).


Danger of electrical short circuit.

Disconnect the battery before performing any work.

- Disconnect battery.

- Remove the bolts - A - from the cover - B -.

- Remove the nut - 1 - 9 ±1 Nm.






- Loosen the retainer on the connector strip - arrow -.


Contact with a hot exhaust system can cause severe burns.

The auxiliary heater heating element may be hot.

Let the auxiliary heater heating element cool down before removing it.

- Remove the bolt - 2 - 1.4 Nm and pull the auxiliary heater heating element out of the blower case.

Installing

• Make sure the ground wire is positioned correctly.

Install in reverse order of removal.