Cylinder Head Cover Overview

Cylinder Head Cover Overview






1 Bolt

• 5 Nm

2 Bolt

• 22 Nm

3 Protective Strip

• For the fuel rail and high pressure lines.

4 Fuel Rail

• With high pressure lines.

• Do not change the angles of the high pressure lines.

• Overview, refer to => [ Fuel Rail and Injectors Overview ] Service and Repair.

5 Bolt

• 5 Nm

6 Sealing Cap

7 Nut

• 10 Nm

8 Tensioning Plate

• Always replace.

• Note the installed position, refer to => [ Tensioning Plate Installed Position ] Service and Repair.

9 Fuel Injector

Overview, refer to => [ Fuel Rail and Injectors Overview ] Service and Repair.

10 Bracket

• For the wiring harness.

11 Vacuum Hose

• Make sure it is seated correctly and is routed without kinks.

• To the wastegate bypass regulator valve.

12 Cylinder Head Cover

• Removing and installing, refer to => [ Cylinder Head Cover ] Cylinder Head Cover.

13 Gasket

• Replace if damaged or leaking.

14 Bolt

• 10 Nm

• Follow the loosening and tightening sequence, refer to => [ Cylinder Head Cover ] Cylinder Head Cover.

15 Cap

• Replace the seal if damaged.

16 Heat Shield

17 Bushing

• For the fuel rail mounting.

• Replace if damaged.