Center Console, Basis, Jetta from MY 10 and Golf Wagon from MY 10

Center Console, Basis, Jetta from MY 10 and Golf Wagon from MY 10

Removing

- Switch off the ignition.

Vehicles with automatic transmission

- Loosen boot from cover.

Vehicles with manual transmission and Direct Shift Gearbox (DSG)

- Loosen boot from cover.

All vehicles

- Remove parking brake lever trim.

- Remove the trim in the center of the instrument panel (Jetta from MY 10, Golf Wagon from MY 10). Refer to => [ Instrument Panel Center Trim, Jetta from MY 2010 and Golf Wagon from MY 2010 ] Instrument Panel Center Trim, Jetta from MY 2010 and Golf Wagon from MY 2010.

- Remove the trim around the heating and A/C controls (Jetta from MY 10, Golf Wagon from MY 10). Refer to => [ Heating and A/C Control Trim, Jetta from MY 2010 and Golf Wagon from MY 2010 ] Heating and A/C Control Trim, Jetta from MY 2010 and Golf Wagon from MY 2010.

- Remove the center cover (Jetta from MY 10, Golf Wagon from MY 10). Refer to => [ Center Cover, Jetta from MY 2010 and Golf Wagon from MY 2010 ] Center Cover, Jetta from MY 2010 and Golf Wagon from MY 2010.

- Remove the two lining mats - 2 - from extension - 4 -.

- Remove lining mat - 5 - from center console.

- Remove the "AUX IN socket" - 1 -, if equipped.

- Remove the three bolts - 3 - (1.5 Nm).

- Loosen extension from mounts.

- Pull parking brake lever extension forward through opening.






- If the vehicle has a manual transmission, remove the noise insulation and shift mechanism - 3 - in the center console.

- Remove the two bolts - 2 - (1.5 Nm).

- Remove the ashtray - 1 - from center console and (depending on vehicle equipment) disconnect the wiring harnesses.

• The vehicle may have a storage compartment in place of an ashtray - 1 -. Removing the storage compartment is identical to removing the ashtray.






- Remove the bolt - 1 - (1.5 Nm).

- Pull left footwell trim - 2 - out of mounts.

• Removal of right footwell trim is identical.

• Be sure to install the footwell trim panel - 2 - into the retainer - 3 - first.






- Remove the two bolts - 4 - (1.5 Nm).

- Remove the bolt - 3 - (1.5 Nm).

- Remove the two bolts - 2 - (1.5 Nm).

- Remove the cover on the center console - 1 - - in direction of arrow -.

• Install the bolts in the following sequence: - 2 -, - 3 - and - 4 -.






- Remove center console - 1 - from vehicle.

• Make sure the center console locks securely into the mounts - arrows - in the instrument panel.