Rear Bumper Cover

Rear Bumper Cover






- Remove the tail lamp assembly.

- Remove screws - 8 - in area of left and right wheel housing liner.

- Pry out left and right expanding rivet - 4 - using a screwdriver.

- Remove bolts - 3, 5 and 6 -.

A second technician is required for the rest of the removal procedure.

- Remove the bumper cover - 7 - parallel to the guide profiles - 1 - and the securing strip - 2 -.

- Disconnect harness connectors of installed electrical components.

Installation






To install, perform the steps used for removal in reverse order.

• Be sure to hold the rear bumper cover parallel when inserting it into the left and right guides.

- Check the parallel alignment and the gap dimensions.

- Remove the bolts - 3, 5, 6 and 8 - to the specification. Refer to => [ Rear Bumper Cover Assembly Overview ] Rear Bumper Cover Assembly Overview.