Shift Forks

Shift Forks

Special tools, testers and auxiliary items required

• Thrust Plate (VW 402)

• Punch (VW 411)

• Tube Trans. Drive Shaft (VW 426)

• Thrust Pad 16.5/28 mm Dia. (VW 431)

• - 1 - Kukko Extractor 18.5-23.5 mm (21/3)

• - 4 - Kukko Support (22/1)






1 Insulation mat

• Can be removed and installed by hand

2 Selector Shaft with Selector Fork, for 1st and 2nd Gear

3 Selector Shaft with Selector Fork, for 3rd and 4th Gear

4 Selector Shaft with Selector Fork, for 5th and 6th Gear

• on some transmission, is also for the reverse gear shift fork bearing

5 Reverse Gear Selector Fork

• On the axle for the reverse gear shift fork, refer to => [ The reverse gear selector fork is mounted on the axle behind the
5th and 6th gear selector shaft. ] Transmission, With a Sealing Cap Circlip For the Input Shaft

• From transmission manufacture date 06 03 6, ball sleeve - item 6 - => [ (Item 6) Ball Sleeve ] has been omitted

• Sliding omission

• The reverse gear shift fork is has been adapted.

• If the axle for the reverse gear shift fork is deleted, bearing on the shift rod for the 5th and 6th gear shift fork => [ Reverse gear selector fork mounted on the selector shaft with the 5th and 6th gear
selector fork. ] Transmission, With a Sealing Cap Circlip For the Input Shaft

• Difference in the reverse gear shift forks, refer to => [ Reverse Gear Selector Fork Differentiation ]

• Refer to the Parts Catalog

6 Ball Sleeve

• Removing, refer to => [ Through Transmission Build Date 5 March
2006 - Remove the Reverse Gear Selector Fork Ball Sleeve ]

• Installing, refer to => [ Through Transmission Build Date 5 March
2006 - Press in the Reverse Gear Selector Fork Ball Sleeve ]

• From transmission manufacture date 06 03 6, ball sleeve - 6 - => [ (Item 6) Ball Sleeve ] has been omitted

• Sliding omission

Reverse Gear Selector Fork Differentiation










Through Transmission Build Date 5 March 2006 - Remove the Reverse Gear Selector Fork Ball Sleeve





A Kukko extractor 18.5-23.5 mm , for example, (21/3)
B Kukko support , for example, (22/1)

Through Transmission Build Date 5 March 2006 - Press in the Reverse Gear Selector Fork Ball Sleeve