Oil Pressure Sender: Service and Repair

Oil Pressure Switch (F1)

Special tools, testers and auxiliary items required

• Socket 24 mm and Jointed Extension (T40175)

Removing

- Remove the noise insulation.

- Remove the left charge air hose - 1 and 2 -.






- Disconnect the harness connector - 1 - from the bracket and disconnect the connector - arrow - from the oil pressure switch.






with a 1 pin Oil Pressure Switch

- Remove the bolt - B - for the ground cable (ignore the arrows).






Continuation for All

- Remove the oil pressure switch using the socket 24 mm and jointed extension (T40175).






Installing

- Insert the oil pressure switch by hand and tighten it to 20 Nm.

• In the case of a 1 pin oil pressure switch, check whether the ground wire is connected.

Further installation is in the reverse order of removal.