Charge Air Hose, Installing

Charge Air Hose, Installing


The connector coupling sealing ring can be damaged if the clamp is in the locked position when installing. This would result in a leak. Follow the assembly instructions.

Removing

- Release the coupling element by pulling the clip - arrow -. Disconnect the hose/pipe without the help of tools.






Installing

- When replacing, ensure that the sealing ring sits all the way around and completely in the groove, and that it is not turned.

- Lubricate the sealing surfaces and the seal.

- Bring the securing clip into the release position - 1 -.






- Slide the charge air hose all the way onto the pipe.

- Bring the clip into the locking position - 2 - and then press on the charge air hose again.

- Check for the correct seating and proper locking of the connector by pulling on the hose.