Rear Lid Adjustment Buffer, Adjusting

Rear Lid Adjustment Buffer, Adjusting

• The following describes adjusting the right adjusting buffer. Adjusting the left adjusting buffer is identical.

• Turn the adjusting buffer - 1 - 90° to remove or install it.






- Loosen the clamping screw - 4 - far enough until it is visible inside the rubber buffer.

- Now pull notched slider - 3 - out of the adjusting buffer - 1 -.

- Set notched slider to dimension - a - = 12.5 mm.






- Close the rear lid with light pressure over the center.

- Open rear lid again.






- Screw in clamping screw - 1 - for adjusting buffer to a depth of dimension - a - = 20 mm.

- Check the adjustment.