Leak Detection Pump: Service and Repair

Leak Detection Pump V144

Removing

- Remove the right rear wheel housing liner..

- Disconnect the vacuum line - 1 -.






- Disconnect the electrical connector - 2 -.

- Disconnect the vent line - 3 - by pressing the release button.

- Remove the nuts - arrows -.

- Remove the leak detection pump with the bracket.

Installing

Install in the reverse order of removal. Note the following:

• The vent line - 3 - must engage audibly.

- Install the right rear wheel housing liner..

Tightening Specifications

- For the tightening specifications, refer to => [ EVAP System Components Overview ] EVAP System Components Overview.