Spray Nozzle Holder For Headlamp Washers

Spray Nozzle Holder For Headlamp Washers

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the spray nozzle with the cap - 1 - from the bumper cover to the stop.






- Unclip the cap - 1 - on both sides from the bearings - arrows - on the spray nozzle holder.

- Lift the retaining hook - arrow - slightly and remove the spray nozzle holder.






Installation

• Use the catches on the spray nozzle holder to adjust how far the cap of the spray nozzle is pulled onto the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Clip the cap onto the spray nozzle holder.

- Remove the lift cylinder.

- Push the spray nozzle holder into the lift cylinder until it locks in place.

- Allow the lift cylinder to retract.

- Check the cap for proper seating on the bumper cover.

- Adjust the cap if necessary by shifting the spray nozzle holder into a higher or lower catch on the lift cylinder.

- Bleed the headlamp washer system after conclusion of the assembly steps. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.

- Check the spray nozzles for the headlamp cleaning system and adjust if necessary. Refer to=> [ Headlamp Spray Nozzles, Adjusting ] Adjustments.