Headlamp Washer Pump: Service and Repair

Headlamp Washer Pump (V11)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

The headlamp washer pump is installed in the tank for the windshield/headlamp washer system in front of the right front wheel.

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the front bumper cover.

- Remove the headlamp washer pump (V11) - 9 - upward out of the tank.






- Release and disconnect the harness connector - 10 - and remove the headlamp washer pump.

• The connecting pipe - 8 - can be removed from the headlamp washer pump - 9 -.

• Remove the securing clip at the connection.

• Remove the connecting pipe - 8 - from the headlamp washer pump - 9 -.

Installation

Installation is performed in the reverse order of removal. Note the following:

- Bleed the headlamp washer system after conclusion of the assembly steps. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.