Parking Lamp Bulb (M1)/(M3)

Parking Lamp Bulb (M1)/(M3)

The left side marker lamp bulb (M1) or right side marker lamp bulb (M3) can be checked via the output diagnostic test mode of the Vehicle electrical system control module (J519).

• During removal and installation, leave the ignition key in the passenger compartment of the vehicle to prevent locking of the doors and automatic activation of the "Coming Home/Leaving Home" functions if applicable.

• To be able to replace the bulbs, it may be necessary depending on the equipment to first remove components adjacent to the headlamp, such as the EVAP canister, fuel filter, or the air filter housing.

• The following figures show the replacement of the left headlamp bulb. The right headlamp bulb is replaced in the same way.

• For reasons of clarity, the headlamp is shown in the uninstalled state. It is not necessary to remove the headlamp in order to remove and install the bulbs.

Removal

- Remove the cover - 1 - from the back of the headlamp.






- Pull the lamp socket - 1 - together with the side marker lamp bulb straight backward out of the reflector.






- Remove the parking lamp bulb - 1 - straight out of the lamp socket - 2 - in the - direction of the arrow -.






Parking lamp bulb: Glass base bulb 12V, W5W

Installation

Install in reverse order of removal. Note the following:

During installation, ensure proper seating of the cap. It is destroyed by entry of water into headlamp.

• The lamp socket must be securely engaged in the reflector.

- Check the headlamp functions.

- Check the headlamp adjustment and adjust if necessary.