Center Mounted Brake Lamp Bulb: Service and Repair

High-Mounted Brake Lamp Bulb (M25)

Removal

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the rear lid trim.






- Disconnect the connector - 2 -.

- Unscrew all 7 mounting bolts - arrows B -.

- Press the latching mechanisms - arrows A - inward and remove the high-mounted brake lamp from the rear lid.

Installation

Installation is performed in the reverse order of removal. Note the following:

• When inserting the high-mounted brake lamp bulb in the cut-out in the rear lid, the groove at the top in the center of the brake lamp housing must be pushed onto the guide on the rear lid.

• During installation, ensure proper seating of the seal.

Tighten the mounting bolts of the high-mounted brake lamp bulb on the rear lid to 2.5 Nm.