Brake Pedal, Separating from Brake Booster

Brake Pedal, Separating from Brake Booster

Special tools, testers and auxiliary items required

• Release tool (T 10159)

- Remove trim on driver side.

Only on vehicles with brake light switch on mounting bracket:

- Disconnect connector from brake light switch.

- Remove brake light switch by turning 45° to left.

Procedure for all vehicles:

- First press brake pedal in direction of brake booster and hold.






2 Pressure Rod
3 Retaining Lugs

- Insert (T 10159) and pull in direction of driver seat. When doing this, counter-hold on brake pedal. (At this moment the pedal must not be allowed to move backward). The mounting retaining lugs - 3 - will thereby be pressed off the ball head of the push rod - 2 -.

For ease of illustration separating the brake pedal from the brake booster is shown with the pedal assembly removed.

- Pull (T 10159) and brake pedal together toward the driver seat. (This will pull the brake pedal off the push rod ball head).

Brake Pedal and Brake Booster, Connecting

- Hold ball head of push rod in front of mounting and push brake pedal in direction of brake booster, so the ball head engages audibly.






Install in reverse order of removal.

Only on vehicles with brake light switch on mounting bracket:

- Brake lamp switch, installing, refer to => [ Brake Lamp Switch (F), through 04 November 2005 ] Brake Lamp Switch (F), through 04 November 2005.