Front Level Control System Sensors G78/G289

Front Level Control System Sensors G78/G289

Special tools, testers and auxiliary items required

• Torque Wrench (5-50 Nm) (V.A.G 1331)

Removing

• In order to be able to remove the left front level control system sensor, the steering wheel must be turned all the way to the right; this assures that there is enough clearance between the control arm and the stabilizer bar.

• In order to be able to remove the right front level control system sensor, the steering wheel must be turned all the way to the left, this assures that there is enough clearance between the control arm and the stabilizer bar.

- Disconnect the connector.






- Remove the bolt and the nut.

- Remove the left front level control system sensor.

Installing

Install in the reverse order of removal. Note the following:

• The level control system sensor lever must point toward vehicle exterior.

• The threads on the level control system sensor must be installed into the front hole in the control arm. The tab on the level control system sensor retainer must lock into the rear hole in order to assure a correct installed position.

- Perform a headlamp basic setting. Refer to the vehicle diagnostic tester.

Tightening Specifications