Piston, C60 Caliper

Piston, C60 Caliper

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• Piston Resetting Tool (T10145)

Removing

- Force piston from brake caliper using compressed air.

Place a wooden board into the recess of the caliper housing so it is not damaged.






- Remove seal with (3409).






When removing, make sure that surface of cylinder is not damaged.

Installing

- Clean the surfaces on the pistons and seal with mineral spirits.

- Apply a thin coat of installation paste G 052 150 A2 on the piston and the seal before installing.

- Insert oil seal into brake caliper.

- Place the cap with the outer sealing lip on the piston.






- Insert inner sealing lip in cylinder groove with (3409).






Hold the piston in front of the brake caliper for this procedure.

- Press the piston into the brake caliper using piston resetting tool.






Outer sealing lip of the protective cap will then engage in piston groove.