Seat Bench Cover and Upholstery, with Integrated Child Seat

Seat Bench Cover and Upholstery, with Integrated Child Seat

• The work described is for the right child seat in the Passat bench seat from MY 2006. The work for the left child seat in the bench seat for the Passat from MY 2006 and the right and left child seats in the seat bench for the Passat Wagon from MY 2006 is the same, except for minor changes.

Removing

- Remove the bench seat:

• Passat from MY 2006, refer to => [ Seat Bench, Passat from MY 2006, Passat CC from MY 2009 and CC from MY 2010 ] Seat Bench, Passat from MY 2006, Passat CC from MY 2009 and CC from MY 2010

• Passat Wagon from MY 2006, refer to => [ Seat Bench, Passat Wagon from MY 2006 ] Seat Bench, Passat Wagon from MY 2006

- Swivel integrated child seat - 1 - upward.

- Release the two retaining hooks - A arrows - and remove foot compartment - 2 - from mounts in the bench seat.

• Before installing the foot compartment - 2 -, evenly pull cover fabric - 3 - taut - arrow B - until it is free of wrinkles.






- Swing integrated child seat - 1 - downward.

- Remove upholstery clips - 2 -.

- Swing integrated child seat - 1 - back up.

- Open zip fastener - 3 - all around.






- Remove the four pop rivets - arrows - and remove the child seat - 1 - from the seat frame.






- Remove all of the upholstery clips - 4 - all around.

- Loosen the molding seal - 2 - from the mounts in the trim - 1 -.

- Loosen the two molding seals - 3 - from the mounts in the child seat adjusting unit.






- Fold the cover - 2 - up at the outer edges.

- Remove the two upholstery clips each on both sides - 4 -.

- Remove the cover - 2 - with the upholstery - 3 - from the child seat adjusting unit - 1 -.

• The cover - 2 - is bonded with the upholstery - 3 -. They cannot be separated from each other without destroying them and they must be replaced together.






Installing

- Install in reverse order of removal.

• When securing the cover on the child seat adjusting unit, use the Upholstery Pliers (V.A.G 1634).

• When securing the integrated child seat the seat pan or seat frame, use the Special Pop Rivet Pliers (V.A.G 1753A).

• Use the "zipper 1J0.881.451" to close.