Passenger Seat Trim, with Pass-Through

Passenger Seat Trim, with Pass-Through

Removing

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat

- Attach the seat to the fixture for seat repair (VAS 6136).

- Pull handle - 2 - upward.






- Press securing clip metal tab - 1 - inward using a small screwdriver and remove handle - 2 - from adjustment lever - 3 -.

• For the sake of illustration, securing clip is depicted as removed in the illustration.

- Remove the securing clip - 1 - from the adjusting lever - 3 -.

- Compress clamping pin - 1 - inward and remove expanding clip - 2 -.

- Remove the bolt - 3 - (3.5 Nm).

- Remove the release lever - 4 - and remove the clip - 5 -.

• Because it is not possible to remove the release lever and the clip without destroying them, the parts should be replaced before installation.

- Loosen the sill-side trim - 6 - and the cover cap - 7 - from the seat.






- Compress clamping pin - 1 - inward and remove expanding clip - 2 -.

- Loosen the tunnel-side cover caps - 3 - and - 4 - from the seat.






Installing

- Install in reverse order of removal.